ریست فکتوری کردن iLO از طریق سی دی SmartStart

Byadmin

ریست فکتوری کردن iLO از طریق سی دی SmartStart

ریست فکتوری کردن iLO از طریق سی دی SmartStart

Ever needed to erase all settings of iLO and restore the factory settings? If you are an Administrator of HP Proliant Server, then you might have come across in a situation where you have to reset the HP Integrated Lights-Out (iLO) to Factory default settings. There can be numerous reasons to perform factory reset of iLO on your server. Here, in this article I will share the most commonly used methods to reset HP Integrated Lights-Out (iLO) to HP Factory default settings.

iLO Chip

When you reset iLO to Factory defaults, you will lose all your iLO Network settings, all user accounts, iLO Advanced license information and passwords etc. So ensure that you perform this action only when you really know what you are doing!. You cannot restore your old configuration once the factory reset is applied. Once the factory defaults are loaded, you may need to find the default user name and password of iLO to re-configure again. Default user name and password information will be available on iLO tag of your HP Server.

Note: If you are using 100 series HP Servers, then this article will not apply to you. Because 100 series HP Proliant Servers are shipped with LO100 and the method to reset LO100 to factory default is completely different.

Reset iLO to factory default using HP SmartStart CD:

You can launch Lights-out configuration utility from HP SmartStart CD and reset your HP iLO configuration to factory defaults. This method will work only if you are using G7 or below series (G6, G5, G4 etc.) of HP Proliant Servers. This method will not work on latest HP Proliant Gen8 and Gen9 servers because these servers do not use SmartStart CDs rather they use Intelligent Provisioning.

Note: Backup your iLO Advance license key (if installed) before you reset iLO to factory defaults.

Here are the steps you need to follow to reset your iLO to factory defaults. I expect that you already own a SmartStart CD, if not, please download it from HP.com.

1. Boot your HP Server using HP SmartStart CD.
2. Once SmartStart CD is loaded, click on Maintenance button (check screenshot).

Homepage of HP SmartStart CD 8.7

3. Now you can many utilities like ACU, Insight Diagnostics etc. (screenshot provided below).
4. Click on HP Lights-Out Configuration utility.

Launch HP Lightsout Configuration from SMartStart

5. Lights-Out Configuration Utility will launch.
6. Click on Reset link as shown below.

Summary Page of Lights-OUT configuration Utility

7. Here you can find two buttons (Reboot and Reset).
8. To restore iLO to factory default settings, click on Reset button as shown below.

Reset to Factory Default settings using SmartSTart

While you restore iLO to factory default settings, your server fans might run at full speed. This is an expected behavior. Let me know whether you were able to sucessfully reset iLO on your server? Did you face any issue while re-configiring iLO? Let me know how it went!

 

About the author

admin administrator

Leave a Reply

five × 3 =